| 1) |
Take the circular cover and wrap the tape around it with
the sticky part of the tape facing out. |
| 2) |
Coil the wire around the plastic cover (in the middle)
about 25 times. |
| 3) |
Wrap an additional piece of tape over the coil of wire. |
| 4) |
Magnetize the bobbie-pin and hang it inside the plastic
cover by a thin thread, using a little glue. |
| 5) |
Glue the cover to the block of wood. |
| 6) |
Remove the plastic insulation from the ends of two pieces
of wire and the ends of the wire coil. Attach one wire to each end of the
wire coil. |
| 7) |
Insert two small nails into the wood block. Wrap the
wire ends round the nails. |
| 8) |
Join these wires to the battery. |
